IoTReady - Printer Debugging Steps
By IoTReady Support on August 6, 2024
Beginner- Please make sure the printer model connected to the device is Argox CP2140.
- Check USB connection to the printer and try reinserting the USB cable.
- Please ensure the printer is powered by 24v power supply.
- Check green LED while print is triggered.
- Check if green LED is continuously on when no prints are triggered.
Resetting Printer to Factory Defaults:
- Turn on the printer and wait till both "Ready" indicator and "Power" indicator stay solid green.
- Press the "FEED" button for 4 seconds and the "Ready" indicator and "Power" indicator will go off in order.
- Once the "Power" indicator becomes lit again, release the "FEED" button.
- "Ready" indicator will then become lit too. At this moment, the printer has resumed its factory default settings.
Printer will delete those print tasks received but not yet printed.
Was this article helpful?
More articles on USB Labeling Devices